POOL OPEN/CLOSE INSTRUCTIONS

Pool Open/Close kit is a non-chlorine kit using Enzyme technology along with Phosphate Remover and Scale & Metal Control. This kit is approved to treat 10,000 gallons of water. The three products in collaboration will provide exceptional contaminate removal along with providing a protection for plaster.

Opening Directions:

POOL OPENING
Step 1: Take off pool cover
Step 2: Fill pool to middle of tile and turn on equipment.
Step 3: Check all chemical levels and adjust accordingly to industry standards. Do not super-chlorinate.
*pH: 7.4-7.6 *Chlorine: 1-5ppm * Alkalinity: 80-120ppm *Calcium: 200-400ppm *Stabilizer: 35-40ppm
Step 4: add
– 1 quart per 10,000 gallons of Scale & Metal Control
– 1 quart per 10,000 gallons of Enzyme Water Cleaner
– 1 pint per 10,000 gallons of Phosphate Remover Concentrate
Allow the pool to circulate for 24 hours.
Step 5: Vacuum, Brush, and Net the pool after the 24 hours of circulation. Backwash the filter after vacuuming (if necessary).
Step 6: Recheck chemical levels and adjust if necessary.
-if specialty products can be added at a pre-check then do so then.
-add maintenance does of each chemical throughout the swimming season.

Closing Directions:

POOL CLOSING
Step 1: Check all Chemical levels and adjust accordingly to industry standards. Do not super-chlorinate.
Step 2: add
– 1 quart per 10,000 gallons of Scale & metal Control
– 1 quart per 10,000 gallons of Enzyme Water Cleaner
*do not add phosphate remover at closing.
Allow the pool to circulate for 24 hours.
Step 3: Brush and Net the pool after the 24 hours of circulation. Backwash and clean the filter after vacuuming.

Contact Orenda Technologies for Pool Open and Close pool care products