GREEN POOL CLEAN-UP

Instructions based on 10,000 gallons

Day 1

Step #1 – Lower PH to 7.2

Step #2 – Add bleach to raise ppm to 10, do not exceed 10 ppm

Remember that 1 gallon of bleach raises ppm in 10,000 gallons to between 10 ppm – 12 ppm

Step #3 – Add 1 quart of PR 10000

Step #4 – Brush pool and circulate PR 10000, ensure the filter is off at this time

 

Day 2 –

Step #1 – Add 1 quart of CV 600 or CV 700 / 1 quart of SC 1000

Step #2 – Adjust PH to 7.4

Step #3 – Add bleach to raise 5 ppm, no higher than 8 ppm, ensure the filter is off at this time

 

Day 3 & Day 4 –

Step #1 – Vacuum to waste (Day 3 Only)

Step #2 – Adjust all chemicals into proper range, including Alkalinity, PH no higher than 7.4, Stabilizer no more  than 60, Chlorine no higher than 5ppm.

Step #3 – Add Tabs to Feeder or Floater

Step #4 – Clean Filter and run on regular cycle

 

Weekly & Bi-Weekly Maintenance

Step #1 – Keep PH at 7.4

Step #2 – Add 1 – 2 Quarts of Bleach, no more, add tabs

Chlorine should be no higher than 5ppm

Step #3 – Add 4-5 Ounces of CV 600 or CV 700 – Weekly

Step #4 – Add 6 Ounces of SC 1000Bi-Weekly

Step #5 – Adjust all chemicals, and clean filter as needed

 

Monthly Maintenance

Step #1 – Add 1-2 ounces of PR 10000 to maintain low phosphate levels

 

Remember – Phosphate levels should stay below 200ppb and TDS should not be over 2000.  Test every 1-3 months phosphate levels.

             Call Orenda Technologies, Inc. @ 1-866-763-4269 with any questions